UT240-312

Under Table IT Interconnect

  • Easily installs under a table or inside a podium
  • Convenient access to power, AV and network connectors
  • Single power cord
  • Table cutting is not required
  • Low profile design

Want to tell us what you think?
Feel free to post your comments here:
(Please include your email address if you
would like us to respond.)

  User Guide Printable Version

The Edge series from ALTINEX offer a wide variety of options for routing computer audiovisual signals, network connections, and AC power in a cost-effective way. The Edge is easily installed under a table or inside a lectern. It can also be mounted on a side of a lectern or a table leg. For a simple and cost effective installation, The Edge provides unparalleled ease of use and flexibility.

In the past the only way to provide AV connectivity at a conference table or a lectern was to cut the table for wires feed through or to have wires laying on the ground. With the introduction of The Edge, there is now another choice: route cable under table and bring your connectors to the edge of the table. Now in one convenient location, between chairs, users have an easy access to power, network and AV connectors.

The UT240-312 is a North American version which provides 4 standard AC receptacles with 10ft cable, and 4 Network (RJ45 F) snap-in connectors.

The unit also includes a push-to-reset 15A circuit breaker for added protection.

Product Views

Specifications

General

 

Front Panel Connectors

Cable end

AC Power: (4) NEMA Outlet

NEMA plug (10ft)

Network: (4) CAT-6 (RJ45) female

Snap-in connector

Mechanical

electrical

Front width: 10.40in (264mm)

Pass-Through Signals:

Side width: 3.10in (79mm)

All standard audio, video, network, and modem signals are acceptable.

Height: 1.85in (47mm)

Pass-Through AC: 600W max.

Finish: Silver metallic

 

T° Operating: 10°C-35°C

 

T° Maximum: 50°C

 

Humidity: 90% non-condensing

 

Application Diagram

Dimensions

 

Specifications subject to change without notice. Do not use the diagram above to perform table/wall modification.

Copyright © 2007 ALTINEX, Inc. All rights reserved. | v5.0| 1.800.ALTINEX | Terms of Use | Terms & Conditions | Privacy